|
The two starter books that come with the base unit do not require a cartridge. To play with these books, make sure there is no cartridge or any other object inserted into the cartridge port located at the top right side of the unit.
|
|
Yes, the cartridges from your original Smart Cycle® will work with the new Smart Cycle® Extreme
|
|
The power button is the yellow button on the front of the unit. Touch it once to turn the toy on, and again to turn it off. When the product is turned on, the voice will say, “Welcome.” When turned off, voice says “Good-bye.”
|
|
The music mode is similar on many pages. To interrupt the music mode, simply touch any other mode icon on the page (such as the “words” icon), or turn to another page in the book. The music mode on the “Police Officer” page in Ernie’s Neighborhood has an excellent play feature. You may touch objects on the bus as instructed, or even touch other objects on the page to add silly lyrics to the song.
|
|
The light lit at the top of the unit will indicate the active mode of the product. The default mode is the “Words” mode, so whenever you do not actively select a mode, the product will default to the “Words” mode. This will also happen if you make selections that do not correspond with the active mode.
|
Headphones are not included with the unit, but may be used for private listening.
Headphones must be equipped with a 3.5 mm plug and must be stereo. Mono headphones (identified by three bands on the tip of the plug) will fit into the headset jack, but they will not function.
The headset jack is located on the side of the unit with the silver handle, above the speaker area.
If an object is lodged in the headset jack, the unit will not make sound and will, therefore, appear to be malfunctioning. Once the object is removed, the unit emit sound from the speaker.
- If you are using headphones and you touch the book or unit with the headphone wire, it will activate audio responses. It's important to keep the wires away from the touch-sensitive areas of the unit.
|
|
Yes, the cartridges from your Smart Cycle® Extreme will work with the original Smart Cycle
|
|
The batteries are dead or weak. Replace all batteries with fresh, alkaline batteries. Do not mix old and new batteries.
|
During play, the unit must be completely open so that it lies flat. If the unit is even partially closed, the page activation may not work properly thus giving responses for another page, other than the active page .
- If the book is torn, bent, curled, written on, marked up, etc, the unit may not work properly and may not recognize the active page. Taping torn pages will not fix the problem. You will need to replace the damaged books.
- If something is blocking the optical sensors, such as dirt, sand, the user’s hands, etc., the page activation may not work properly.
|
Please go through the following steps to assist in correcting the problem.
- Make sure the RESET switch on the back of the unit is in the ON position.
- Adjust the volume by sliding the volume switch upward.
- After a few minutes, the unit will shut off automatically. To turn the unit back on, simply press the on/off button.
- The batteries are dead or weak. Replace all batteries with fresh, alkaline batteries. Do not mix old and new batteries.
|
|
To adjust the volume of the toy, slide the purple switch (located next to the power button) up to increase volume or down to decrease volume.
|
Please go through the following steps to assist in correcting the problem:
- Make sure the RESET switch on the back of the unit is in the ON position.
- Try sliding the RESET switch OFF, and then back ON again.
- Try sliding the purple Volume Switch up to a louder level.
- Make sure the Power Touch base unit is completely open so that it lies flat.
- Make sure that you are using the right combination of book and cartridge (or no cartridge, as appropriate).
- If you are using one of the two starter books (type of book is indicated on the top right of the cover), please ensure there is no cartridge inserted into the base unit.
- If you are using any other Power Touch book, make sure the corresponding cartridge is fully inserted into the cartridge port at the top of the unit (above the letter “Ee” on the base.) The title on the book cover and the cartridge should match.
- Make sure the book is in good condition. If pages are ripped, curled or bent (especially at the top of the book), then the unit may not work properly, and the book will need to be replaced.
- Make sure the book is correctly loaded into the unit and the pages are lying flat.
|
No, there is no adapter connection available nor recommended for this product.
|
|
To get out of a specific mode at any time and go back to basic exploratory play, simply touch the “Words” mode at the top left side of the page, OR turn to any other page in the book.
|
You can store only one book inside the unit at a time.
- Attempting to store multiple books in the unit will prevent the unit from closing properly.
- The binding of the book must be properly inserted to prevent it from falling out when carrying the unit by the handle.
- A PowerTouch Backpack is available as an optional accessory. The backpack will store the PowerTouch unit plus four books and corresponding cartridges.
|
- To properly load a book, hold the book closed with the cover facing up toward you, fit the top end of the bookbinding into the top of the unit, then lower the bottom end of the book binding into the bottom of the unit.
- Make sure the back cover of the book is lying flat against the right side of the base unit.
- If the book is open to any inside page, make sure the front cover is lying flat against the left side of the base unit.
- Make sure all other pages are lying flat.
- Make sure the book is not upside down.
- You may play with only one book at a time when inside the unit.
- The alphabet on the base unit does not work if a book is loaded into the unit (even though you can see half of the alphabet when using the front cover or back cover of a book.)
|
|
This is an indication of weak or dead batteries. Try inserting a new set of 4 “AA” alkaline batteries.
|
You will sometimes hear a sound effect before you hear the number you are counting. If you count too fast, you will only hear the sound effects. For best results, try to pause slightly in between touches. Occasionally, as you are counting the objects, you may hear the response “you counted that” even though it is the first time you are touching it. This may happen if you roll your finger over the object (the toy reacts as if you have touched it twice.) Try counting the objects by individually touching each object with your fingertip. In most of the “count” games you will need to only count pictures. However, for added challenge in some of the “count” games, you will need to count corresponding words in addition to the pictures, in order to count all correct objects on the page.
- Ernie’s Neighborhood – on the Farmer Page – you may be asked to count “farmers” or “pigs.” You will need to count the word “farmer” (located in the text on the left side of the page), or the word “pig” (highlighted next to the picture of the big pig) in order to complete these tasks.
- Ernie’s Neighborhood – on the Baker Page – you may be asked to count “triangles,” “stars,” or “squares.” You will NOT need to count the corresponding words.
- School Skills Sampler – on the Grade K Page – you may be asked to count “stars,” “little stars,” “big stars,” “crayons,” “squares,” or “triangles.” In order to complete the task, you will need to count the corresponding words as well (e.g. you need to count the word “star” located below the word “Grade,” when asked to count “stars,” “little stars,” or “big stars”.)
|
|
Be sure the RESET Switch (located on the back of the Power Touch unit) is in the ON position. If the product does not seem to be functioning correctly, try sliding the RESET switch to OFF and then back to ON again. If this does not correct the problem, your batteries may be weak or completely dead. Try inserting a new set of 4 “AA” alkaline batteries.
|
|
The battery power is weak and you will need to reset the electronics. Slide the RESET switch on the back of the unit to the OFF position. Replace all batteries with fresh, alkaline batteries. Do not mix old and new batteries. Slide the RESET switch to the ON Position.
|
