|
We'd like to let you know that there have been some design changes made to the Imaginext® DC Super Friends™ Batcave. The gray door located on the front upper portion of the Imaginext® DC Super Friends™ Batcave and telescope base was removed from the product and a rounded end has been added to the telescope. The rounded end will fit into one of the two hex fittings that have been added to the purple platform.
In order to lower the telescope in the elevator, you will need to put the ball on the bottom of the telescope into the raised hexagon opening and have the telescope facing forward. Tip it back and the elevator will now lower.
|
Bigfoot’s battery should be charged for 4 hours. Charging Instructions:
- The LED light on the charger will remain red for 4 continuous hours after being plugged in.
- After 4 hours the LED will turn green.
Please Note: If the charger is unplugged after this time and plugged back in, the LED will turn red again for 4 hours even though the battery is fully charged. The LED is not an indicator as to whether the battery is fully charged.
|
Rotate Bigfoots elbow towards the back of the body for the thumb to latch onto the ball. Do not pull the hand down or forward to give Bigfoot the ball. Once the ball is placed in Bigfoot’s hand correctly, press the ball button on the remote.
|
If Bigfoot stops working, check the following
- Motor Stall – Was there any audible beeps from Bigfoot before he shut down: If audible beeps came from Bigfoot, a motor has stalled.
- 1-Beep = arm motors stall
- 2-Beeps = leg motor stall
- 3-Beeps = head motor stall
To Fix the Motor stall:
- Remove any obstruction from Bigfoot’s path.
- Turn the product off and then back on to restart the product.
- If this stall condition continues to happen when no obstruction is present, there is a malfunction with Bigfoot. Please contact Consumer Relations.
- Low Battery - Did Bigfoot say ‘Low battery’ before he stopped.
- If the battery is low, Bigfoot will say ‘low battery’, and the battery pack needs to be charged.
|
Bigfoot needs to finish a sequence before starting a new sequence. If a sequence is interrupted, Bigfoot will say ‘hey’ or ‘huh’. Wait until the sequence is complete and then try hitting a command again.
|
All Bigfoots use the same signal. You can not operate 2 different Bigfoots at once. They will both be controlled by the same remote.
|