You should place the Apptivity Hot Wheels car on the screen in that location in order to play.
|
We have a network of over 350 Authorized Service Centers to help you with repairs and replacement parts. These Service Centers have skilled personnel and use only genuine Power Wheels replacement parts to fix your vehicle. Use our Service Center Locator to find a service center near you.
|
You can, but the adhesive should be applied to a clean, smooth, dry surface when the temperature is above 50°F (10°C). If the temperature is below 50°F, you can heat the surface with a hair dryer before application.
|
Variations in Hot Wheels cars are the slight differences between cars of the same model. For example, with the many different wheel styles available, the same car model can have a wildly different look just by changing the wheels.
|
Do not place used batteries in your regular trash. Instead, return the battery to a federal or state approved lead-acid battery recycler. This may be a Power Wheels® Authorized Service Center or a local retailer of automotive batteries.
|
-
Once Car Maker instructs you to pull the handle, you must immediately pull it all the way down in one continuous motion until you hear “Complete.” For best results, DO NOT pump handle when pulling it down and complete the injection within 2-3 seconds. If you do not pull it all the way down to complete the injection, Car Maker will keep repeating the phrase, “Please pull down handle.”
|
Battery life will vary depending on how you follow the Charging and Battery Care Instructions. It's also affected by the total number of hours the batteries are used. Average battery life is one to three years.
|
There is a silver-colored speed control button on the lower left side of the screen. The image on it is a gear box. Tap the button to move from “Stop” mode to “Slow” and “Fast” modes.
|
-
From your iPad home screen, go to Settings, General, then Multitasking Gestures. Turn off Multitasking Gestures.
-
Make sure that you do not press the car down on the iPad home button, as that will close the game.
|
To clean the ink off of your car, rub it with a damp cloth and start again!
|
Make sure the pen is fully inserted by pushing it all the way into the slot on the spray gun until you hear/feel it click. Start spraying with the nozzle adjuster pointed all the way toward the negative side (-) and, while holding the trigger down, slowly move the adjuster toward the positive side (+) until you get a nice even spray. If you’re still having issues, please refer to the troubleshooting section below.
|
Use the circular stencil tool to add detail to your artwork. First fully insert the pen until you hear/feel it click and adjust the spray nozzle until you get a nice even spray. Then plug the circular stencil tool directly onto the end of the airbrush tip. Rotate the stencil to select the artwork that you would like to apply. The art should be centered over the spray tip and applied to the car in close range.
|
|
Push the handle on the far right counterclockwise all the way to the ground and the car platform will tip forward, allowing your car to roll out.
|
Medium 3M Command Mounting™ Refill Strips can be used to hang the Hot Wheels® Wall Track™ Playsets.
|
|
You should pull the car back so that your car stays in that location on the screen.
|
The booster needs to be correctly assembled to its designated wall bracket in order to function. The designated wall bracket has a notch on it. This notch ensures the motor only works when attached to the bracket. All other brackets are flat.
Watch set-up instructions for your track.
|
Instructional videos include a review of box contents, items you'll need to get started and helpful tips about Hot Wheels Wall Tracks.
|
There are many reasons that variations exist on the same Hot Wheels car model. For instance, changes may occur in mid-production as a result of a licensing issue or a manufacturing change.
|