The tutorial only plays once, but parts of it can be viewed again by clicking on the map icon on the top left corner of your screen.
|
Always remove the marker from the Monster Maker when printing is complete. Replace cap on marker immediately after use. Store the markers in the tool stand, cap side down, when not in use. If left uncapped, markers will dry out. Markers can be partially restored by replacing the caps and storing them in the tool stand, cap side down, for 24 hours. Use the included markers only with the Monster Maker.
|
-
The very first time you use Car Maker, you need to insert 2 wax sticks. Car Maker comes pre-loaded with 1 wax stick. The second stick you insert is not meant to fit completely inside the machine – it will protrude through the top. After you have made your very first car, only 1 additional wax stick needs to be inserted every time. Please note that ALL wax sticks must be inserted with the point side down.
|
The more you play the game, the more credits you earn. You can redeem credits in the workshop. Your credits are listed in the top right corner of the screen.
|
|
- Change batteries
- Check for obstructions around moving parts
|
On
the underside of the launcher, each end of the rubber band should be wrapped
around a peg on each side of the main launcher and then doubled up and hooked
around the center tab of the moveable portion of the launcher.
Here is a picture of an assembled rubber band launcher!
|
|
-
Touch the screen with your finger to move forward to the next page.
-
If the game keeps freezing, try doing a hard reset.
-
Click the home button on your iPad to get to the home screen.
-
Then double-click the home button again. The multitasking bar will appear.
-
Touch the thumbnail of the Apptivity game until it wiggles, and then touch the minus button.
-
Then click the home button again, and restart the game by clicking the thumbnail for the game on your home screen.
|
The Hot Wheels Car Maker Troubleshooting Guide will help with any questions that arise during the car making process.
|
|
https://qservice.corp.mattel.com/us/Docs/
|
You need to fine tune the spray nozzle by turning the adjustment nozzle all the way to the negative side (-). Then while holding the trigger down, slowly adjust the nozzle toward the positive side (+) until you get a nice even spray. You should also make sure that the pen is fully inserted by pushing it all the way into the slot on the spray gun until you hear/feel it click.
|
First insert the flexible stencils into the frame with the built-in peg fitting. Connect the frame onto the four posts on top of the car decoration turntable, and then adjust the height of the frame for tall and low cars by using the two detent locations. Remember that in order to spray using stencil, the airbrush must face directly down over the top of the car and spray through the stencil.
|
The enter button on your DVD remote may also be called select, set, return, etc.
|
- If you have inserted different colored wax sticks next to each other, you may get some color blending (in which the wax from the two adjacent sticks mix when creating the car body).
|
Our monitors should only be used with Fisher-Price wall adapters to ensure the safety of the monitor.
Adapters should only be replaced with an original Fisher-Price wall adapter. If you need to purchase an adapter, please visit our online store.
|
Consult with your Read With Me instruction manual. You will need to program your Read With Me controller using method 2 - using manufacture codes, or method 3 - manual search.
|
You should place the Apptivity Hot Wheels car on the screen in that location in order to play.
|
-
Once Car Maker instructs you to pull the handle, you must immediately pull it all the way down in one continuous motion until you hear “Complete.” For best results, DO NOT pump handle when pulling it down and complete the injection within 2-3 seconds. If you do not pull it all the way down to complete the injection, Car Maker will keep repeating the phrase, “Please pull down handle.”
|