Connect the controller to a powered USB port with the supplied USB cable. Attach the power cable located inside the controller to Barbie™ Star Light Adventure RC Hoverboard. Set the toy to OFF position and controller in “charging” position (left). Charging light should be in red and turns green when it is fully charged.

To clean the ink off of your car, rub it with a damp cloth and start again!

The booster needs to be correctly assembled to its designated wall bracket in order to function.   The designated wall bracket has a notch on it.  This notch ensures the motor only works when attached to the bracket.  All other brackets are flat. 

Watch set-up instructions for your track.

• Once Car Maker instructs you to pull the handle, you must immediately pull it all the way down in one continuous motion until you hear “Complete.” For best results, DO NOT pump handle when pulling it down and complete the injection within 2-3 seconds. If you do not pull it all the way down to complete the injection, Car Maker will keep repeating the phrase, “Please pull down handle.”

 

 

On average an engine should run 2-3 hours using alkaline batteries.

Try replacing batteries and make sure there are no cracks in the propellers. If there is a crack in the propeller, do not operate toy. If your cat is still not flying, please contact Mattel Consumer Services.

The size of a Matchbox vehicle is 1:64 scale, and can range between 3-4 inches in length. 

The cradles attach to the underside of the transition tracks on the Cliff Hangers race sets.

The Hot Wheels Car Maker Troubleshooting Guide will help with any questions that arise during the car making process.

• If you cannot press the handle down, have an adult unplug the machine, wait ten seconds and then plug it back in to reset. Car Maker will automatically go into the cooling cycle. Do not unplug during this time. After you hear “Cooling Complete” and the door opens, try the following:
• Check the mold for blockage. See CLEANING section in the instruction sheet.
• Look into the front window on the machine. Ensure that there is a wax stick in the heating chamber and that the wax stick above it is properly aligned.

Thomas the Tank Engine Parts are available in the Replacement Parts & Add-ons section of our service website. 

You should place the Apptivity Hot Wheels car on the screen in that location in order to play.

Retailers nationwide, subject to availability.

The battery pack is located on the doll’s back. Remove the skirt and vest, bend the doll’s arms gently if needed.  Unscrew the battery cover at the back with a Philips head screwdriver and replace. Be sure to dispose of batteries properly.

We stock replacement Little People figures, parts, and accessories in the Replacement Parts & Add-ons section of our service website.

Fully charged, the Star Light Adventure Galaxy Barbie® Doll & Flying Cat will fly for about 20 minutes.

Variations in Hot Wheels cars are the slight differences between cars of the same model.  For example, with the many different wheel styles available, the same car model can have a wildly different look just by changing the wheels.

• The very first time you use Car Maker, you need to insert 2 wax sticks. Car Maker comes pre-loaded with 1 wax stick. The second stick you insert is not meant to fit completely inside the machine – it will protrude through the top. After you have made your very first car, only 1 additional wax stick needs to be inserted every time. Please note that ALL wax sticks must be inserted with the point side down.

 

 

No. Barbie is attached to the hoverboard.

• You need to hold the door closed and press the button above it to lock the door. Do not try to open the door during the heating or cooling cycle when it is locked.