No. The setup of your controller is required only one time for each DVD player with which you are using your InteracTV controller. If you have correctly setup your controller with the software that was included with your InteracTV controller, the controller should work with the separately sold software titles.
InteracTV™ is a mark of Beep Telecommunications and computing, L.L.C. Used under license.
|
You only need to set up your InteracTV controller one time per DVD player. Your InteracTV controller can be set up to be played with up to three different DVD players. There is a 3-position memory switch on the underside of your InteracTV controller. Each position of the switch can be programmed to a different DVD player. Refer to your InteracTV User's Manual for instructions on how to use the 3-position memory switch.
InteracTV™ is a mark of Beep Telecommunications and Computing, L.L.C. Used under license.
|
Here are some tips that may help you during the quick setup:
- Make sure you are using fresh alkaline batteries inside your InteracTV controller.
- If you have followed the instructions on the quick setup sheet and your InteracTV controller is still not working with your DVD player, try the setup sheet again from the beginning. It is possible that one of the numbers did not register when you entered in your DVD code.
- When pressing the numbers on the programming card, make sure your press each number firmly and slowly. The green light on your controller should blink one time after each number is pressed. When the fourth digit is pressed, make sure the green light on your InteracTV controller blinks one long blink. If you do NOT see this long blink, remove the programming card, re-insert it into the controller and try the same code again.
InteracTV™ is a mark of Beep Telecommunications and Computing, L.L.C. Used under license.
|
If your DVD player is not responding to your InteracTV controller please try the following:
- Make sure you have set up your InteracTV controller correctly.
- Try moving your InteracTV controller closer to the TV.
- Replace the batteries on your InteracTV controller.
- Make sure your InteracTV controller is pointed directly at your DVD player.
- Always be sure your hand and the activity card are not covering the red window on the front of the InteracTV controller when removing and inserting an activity card.
- Make sure there are no large objects between your InteracTV controller and your DVD player. Large objects can block the signal between your controller and DVD player.
- When changing activity cards, always make sure you remove the activity card from your InteracTV controller slowly, wait a few seconds, and then insert another activity card.
- Double check that the 3-position memory switch on the underside of your InteracTV controller is in the proper position. Refer to your InteracTV User's Manual for instructions on how touse the 3-position memory switch.
InteracTV™ is a mark of Beep Telecommunications and Computing, L.L.C. Used under license.
|