• The LED light on the charger will remain red for 4 continuous hours after being plugged in.
• After 4 hours the LED will turn green.

• Battery installation instructions are on instruction sheet
• Remove 2 Phillips-head screws located on bottom of train

*Do not remove triangular-head screws

If your DVD player is not responding to your Read With Me™ controller please try the following:

•  Make sure you have setup Read With Me™ controller correctly. The quick setup sheet can be found at www.service.fisher-price.com and the latest list of codes can be found at www.service.fisher-price.com 
•  Try moving your Read With Me™ controller closer to the TV. 
•  Replace the batteries on your Read With Me™ controller. 
•  Make sure your Read With Me™ controller is pointed directly at your DVD player. 
•  Always be sure your hand and the activity card are not covering the red window on the front of the Read With Me™ controller when pressing a button to respond to an activity. 
•  Make sure there are no large objects between your Read With Me™ controller and your DVD player. Large objects can block the signal between your controller and DVD player. 
•  Double check that the 3-position memory switch on the underside of your Read With Me™ controller is in the proper position. Refer to your Read With Me™ User’s Manual for instructions on how to use the 3-position memory switch.

Please restart the Smart Remote programming process, and retest the controller.  If this method is unsuccessful, please check the latest DVD code list to find the proper code for your DVD player. The latest code listing can be found at www.service.fisher-price.com.  Also, if you do not have your quick setup sheet, you can download it at www.service.fisher-price.com. Please try setting up your Read With Me™ again using this Smart Remote method and quick setup sheet.

Here are some tips that may help you during the quick setup: Make sure you are using fresh alkaline batteries inside your Read With Me™ controller.

• If you have followed the instructions on the quick setup sheet and your Read With Me ™ controller is still not working with your DVD player, try the setup again from the beginning.
•  It is possible that one of the signals did not register when pressed on your DVD player’s remote.
• When pressing the numbers on your DVD remote be sure to wait for the audio prompt to finish and the LED on the Read With Me™ controller turns on.

• Change batteries
• Check for obstructions around moving parts

The Imaginext® DC Super Friends™ RC Transforming Bat Bot’s remote is shipped without batteries, so please be sure to place two AAA batteries into the remote.  Also, there is a clear plastic packaging tab that is attached to the outer leg of the non-battery leg of the robot.  The tab should come out of the leg when removed from the box; however, it’s possible that a piece of the plastic remained in the slot on the leg.  Please check the slot, which is located behind the front wheel.  If you see clear plastic protruding from the slot, carefully remove it with tweezers, and turn the toy off and on again.  This should clear the slot and make the toy function as it normally should.

If Bigfoot stops working, check the following

• Motor Stall – Was there any audible beeps from Bigfoot before he shut down: If audible beeps came from Bigfoot, a motor has stalled.
  • 1-Beep = arm motors stall
  • 2-Beeps = leg motor stall
  • 3-Beeps = head motor stall

To Fix the Motor stall:

• Remove any obstruction from Bigfoot’s path.
• Turn the product off and then back on to restart the product.
• If this stall condition continues to happen when no obstruction is present, there is a malfunction with Bigfoot.  Please contact Consumer Relations.
• Low Battery - Did Bigfoot say ‘Low battery’ before he stopped.
  • If the battery is low, Bigfoot will say ‘low battery’, and the battery pack needs to be charged.