|
|
|
The enter button on your DVD remote may also be called select, set, return, etc.
|
We'd like to let you know that there have been some design changes made to the Imaginext® DC Super Friends™ Batcave. The gray door located on the front upper portion of the Imaginext® DC Super Friends™ Batcave and telescope base was removed from the product and a rounded end has been added to the telescope. The rounded end will fit into one of the two hex fittings that have been added to the purple platform.
In order to lower the telescope in the elevator, you will need to put the ball on the bottom of the telescope into the raised hexagon opening and have the telescope facing forward. Tip it back and the elevator will now lower.
|
Click here for the assembly video.
|
Depress the button with “EZ” sculpted on it; located on top of the engine.
|
Click here for the assembly video.
|
You only need to setup your Read With Me™ controller one time per DVD player. Your Read With Me™ controller can setup to be played with up to 3 different DVD players. There is a 3-position memory switch on the underside of your Read With Me™ controller. Each position of the switch can be programmed to a different DVD player. Refer to your Read With Me™ User’s Manual for instructions on how to use the 3-position memory switch.
|
No. The setup of your controller is only required one time for each DVD player with which you are using your Read With Me™ controller. If you have correctly setup your controller with the software that was included with your Read With Me™ controller, the controller should work with the separately sold software titles.
|
GeoTrax replacement parts are available at our Parts Store.
|
Follow the steps below to reset the Read With Me™ controller and restart the programming process:
- Place the face plate back on the Read With Me™ remote briefly.
- Press any single button and remove the cover.
- This will restart the set up mode and the remote will prompt you to "place DVD remote in front of the Read With Me™ remote".
|
- Change batteries
- Check for obstructions around moving parts
|
If Bigfoot stops working, check the following
- Motor Stall – Was there any audible beeps from Bigfoot before he shut down: If audible beeps came from Bigfoot, a motor has stalled.
- 1-Beep = arm motors stall
- 2-Beeps = leg motor stall
- 3-Beeps = head motor stall
To Fix the Motor stall:
- Remove any obstruction from Bigfoot’s path.
- Turn the product off and then back on to restart the product.
- If this stall condition continues to happen when no obstruction is present, there is a malfunction with Bigfoot. Please contact Consumer Relations.
- Low Battery - Did Bigfoot say ‘Low battery’ before he stopped.
- If the battery is low, Bigfoot will say ‘low battery’, and the battery pack needs to be charged.
|
All Bigfoots use the same signal. You can not operate 2 different Bigfoots at once. They will both be controlled by the same remote.
|