You should place the Apptivity Hot Wheels car on the screen in that location in order to play.
|
|
You can, but the adhesive should be applied to a clean, smooth, dry surface when the temperature is above 50°F (10°C). If the temperature is below 50°F, you can heat the surface with a hair dryer before application.
|
Hot Wheels replacement parts are available at our
Parts Store.
|
Variations in Hot Wheels cars are the slight differences between cars of the same model. For example, with the many different wheel styles available, the same car model can have a wildly different look just by changing the wheels.
|
Click here to see the instructions on how to perform a hard factory reset on your tablet.
|
After the figures are connected, cranked up and the head is pushed, the “wrestling” feature does not last long.
- Crank the lever clockwise until it clicks, usually about 11 times, for full power battling.
|
-
Once Car Maker instructs you to pull the handle, you must immediately pull it all the way down in one continuous motion until you hear “Complete.” For best results, DO NOT pump handle when pulling it down and complete the injection within 2-3 seconds. If you do not pull it all the way down to complete the injection, Car Maker will keep repeating the phrase, “Please pull down handle.”
|
There is a silver-colored speed control button on the lower left side of the screen. The image on it is a gear box. Tap the button to move from “Stop” mode to “Slow” and “Fast” modes.
|
-
From your iPad home screen, go to Settings, General, then Multitasking Gestures. Turn off Multitasking Gestures.
-
Make sure that you do not press the car down on the iPad home button, as that will close the game.
|
To clean the ink off of your car, rub it with a damp cloth and start again!
|
The action button is the button on the hood of the car that you can press down in order to start the game, activate weapons, enter buildings and other zones, and more.
|
The WWE Power Slammers figures are difficult to connect at the arms the first couple of times. Each time you connect the figures, it will become easier and easier to connect.
The new figures released in the Fall 2013 will be easier to connect.
|
Make sure the pen is fully inserted by pushing it all the way into the slot on the spray gun until you hear/feel it click. Start spraying with the nozzle adjuster pointed all the way toward the negative side (-) and, while holding the trigger down, slowly move the adjuster toward the positive side (+) until you get a nice even spray. If you’re still having issues, please refer to the troubleshooting section below.
|
In order for the Wild Thing™ to operate correctly, there must be weight in the seat. When your child leans forward in the seat or lifts their bottom off the seat, the seat switch will open and the vehicle will stop. For best results, make sure your little one stays seated at all times with their back against the seat.
|
Use the circular stencil tool to add detail to your artwork. First fully insert the pen until you hear/feel it click and adjust the spray nozzle until you get a nice even spray. Then plug the circular stencil tool directly onto the end of the airbrush tip. Rotate the stencil to select the artwork that you would like to apply. The art should be centered over the spray tip and applied to the car in close range.
|
|
Push the handle on the far right counterclockwise all the way to the ground and the car platform will tip forward, allowing your car to roll out.
|
Since 1968, when Hot Wheels cars were introduced, we have manufactured tracks in many different colors, yet the color that sticks in the minds of most people is orange. As in the past, we will continue to manufacture tracks in many different colors that will vary from set to set, and year to year.
|
Medium 3M Command Mounting™ Refill Strips can be used to hang the Hot Wheels® Wall Track™ Playsets.
|