|
Use your Email app to create a message, then browse your Photo app to find the photo and attach it to the email.
|
Touch the item you want to swap, then drag your finger left or right to cycle through the options.
|
Your photos are saved automatically to the Photo app on your device.
|
For best results, make sure doll parts are clean and dry before installing in Monster Maker. If your design did not print completely, erase ink using the provided sponge. Add water and a little dish soap (not included) and rub with the sponge until the ink is removed. Dry the doll part thoroughly before putting it back in the Monster Maker.
|
|
|
-
If you hear “Error,” ask an adult to unplug Car Maker from the wall, wait ten seconds and then plug it back in to reset. Car Maker may automatically go into the cooling cycle. Do not unplug during this time. If you continue to hear “Error” after multiple resets, this may be an indication of a mechanical problem with the door switch; please contact Consumer Services via service.mattel.com for assistance.
|
If Barbie™ Star Light Adventure RC Hoverboard keeps moving after launching, use the Trim buttons, located around the joystick to adjust. Press Trim button in opposite direction where Barbie™ Star Light Adventure RC Hoverboard moves until it remains still in the air. Press once and wait a few seconds until it is stabilized.
|
|
-
Yes, for best results, allow the wax to cool for a few minutes before opening the mold. Twist the mold slightly (as you would an ice cube tray) to break the wax free. You can also run the mold under cold water, which will help speed up the cooling process. If the car body is wet, be sure to dry it completely before applying labels. Remove car body from the mold within 10 minutes. If the body is left in the mold for any longer, the wax may begin to crack.
|
The joystick directions match the direction that Barbie is facing, rather than the direction that the operator is facing. If Barbie is facing away from you and you move the joystick forward, Barbie will fly away from you. If she is facing towards you and you move the joystick forward, she will move towards you.
|
|
Retailers nationwide, subject to availability.
|
|
You will need a powered USB port from a computer, laptop or USB charger.
|
Always remove the marker from the Monster Maker when printing is complete. Replace cap on marker immediately after use. Store the markers in the tool stand, cap side down, when not in use. If left uncapped, markers will dry out. Markers can be partially restored by replacing the caps and storing them in the tool stand, cap side down, for 24 hours. Use the included markers only with the Monster Maker.
|
|
-
The very first time you use Car Maker, you need to insert 2 wax sticks. Car Maker comes pre-loaded with 1 wax stick. The second stick you insert is not meant to fit completely inside the machine – it will protrude through the top. After you have made your very first car, only 1 additional wax stick needs to be inserted every time. Please note that ALL wax sticks must be inserted with the point side down.
|
Fully charged, the Barbie™ Star Light Adventure RC Hoverboard will fly for about 7 minutes.
|