|
For best results, make sure doll parts are clean and dry before installing in Monster Maker. If your design did not print completely, erase ink using the provided sponge. Add water and a little dish soap (not included) and rub with the sponge until the ink is removed. Dry the doll part thoroughly before putting it back in the Monster Maker.
|
Touch the item you want to swap, then drag your finger left or right to cycle through the options.
|
Use your Email app to create a message, then browse your Photo app to find the photo and attach it to the email.
|
Your photos are saved automatically to the Photo app on your device.
|
|
-
The very first time you use Car Maker, you need to insert 2 wax sticks. Car Maker comes pre-loaded with 1 wax stick. The second stick you insert is not meant to fit completely inside the machine – it will protrude through the top. After you have made your very first car, only 1 additional wax stick needs to be inserted every time. Please note that ALL wax sticks must be inserted with the point side down.
|
|
No. Mattel meets or exceeds all safety guidelines developed and enforced by the Consumer Product Safety Commission, a government regulatory agency. For additional information on safety and sustainability, consumers can go to our website http://citizenship.mattel.com and then click on Safe and Sustainable Products.
|
-
Once Car Maker instructs you to pull the handle, you must immediately pull it all the way down in one continuous motion until you hear “Complete.” For best results, DO NOT pump handle when pulling it down and complete the injection within 2-3 seconds. If you do not pull it all the way down to complete the injection, Car Maker will keep repeating the phrase, “Please pull down handle.”
|
The Barbie™ Star Light Adventure RC Hoverboard is meant for indoor use. The toy may not work properly when used outdoors and will be affected by wind and/or heat.
|
The battery pack is located on the doll’s back. Remove the skirt and vest, bend the doll’s arms gently if needed. Unscrew the battery cover at the back with a Philips head screwdriver and replace. Be sure to dispose of batteries properly.
|
-
If you cannot press the handle down, have an adult unplug the machine, wait ten seconds and then plug it back in to reset. Car Maker will automatically go into the cooling cycle. Do not unplug during this time. After you hear “Cooling Complete” and the door opens, try the following:
-
Check the mold for blockage. See CLEANING section in the instruction sheet.
-
Look into the front window on the machine. Ensure that there is a wax stick in the heating chamber and that the wax stick above it is properly aligned.
|
The Barbie™ Star Light Adventure RC Hoverboard will fly about 5 meters or 17 feet from the surface it launches from.
|
-
PC: Windows Vista, Windows 7, Windows 8, Windows 8.1, Intel® Core™ i3 Processor, 2 GB RAM
|
Four AAA batteries are required, but are not included.
|
|
Make sure you have e-mail on your device and that you have phone service or WiFi.
|
|
Connect the controller to a powered USB port with the supplied USB cable. Attach the power cable located inside the controller to Barbie™ Star Light Adventure RC Hoverboard. Set the toy to OFF position and controller in “charging” position (left). Charging light should be in red and turns green when it is fully charged.
|