|
|
Always remove the marker from the Monster Maker when printing is complete. Replace cap on marker immediately after use. Store the markers in the tool stand, cap side down, when not in use. If left uncapped, markers will dry out. Markers can be partially restored by replacing the caps and storing them in the tool stand, cap side down, for 24 hours. Use the included markers only with the Monster Maker.
|
In the drawer, on the right side of the printer.
|
-
Monster Maker is made for iPad Air, iPad mini with Retina display, iPad (4th generation), iPad mini, and iPad (3rd generation). iOS 7.0 or higher is required.
-
Monster Maker is compatible with Samsung Galaxy Tab®, Samsung Galaxy Tab® 2, Samsung Galaxy Tab® 3, Samsung Galaxy Tab®, 8.9, Samsung Galaxy Tab® 10.1, Samsung Galaxy Note®, Google Nexus 7 (2012), Google Nexus 7 (2013), Google Nexus 10, Sony Xperia™ Tablet Z, Toshiba Excite™.
|
|
Additional red, purple, and black markers are available in the Monster Maker Primary Extension Pack, sold separately.
|
|
Next to the On/Off switch, behind the rubber plug.
|
-
PC: Windows Vista, Windows 7, Windows 8, Windows 8.1, Intel® Core™ i3 Processor, 2 GB RAM
|
|
|
The app may display this message if the doll part is not installed completely. Make sure that the doll part is installed per the instructions, and that the carriage slide is lined up with the doll part icon.
|
For best results, make sure doll parts are clean and dry before installing in Monster Maker. If your design did not print completely, erase ink using the provided sponge. Add water and a little dish soap (not included) and rub with the sponge until the ink is removed. Dry the doll part thoroughly before putting it back in the Monster Maker.
|
Please go to
service.mattel.com
to request replacement parts . Please store the adapters in the tool stand when not in use.
|
|
|
No, Windows and Mac computers are supported only through USB. Please connect Monster Maker to your computer with a standard A-to-B USB printer cable (not included).
|
|
If you receive an error message during printing, turn off the Monster Maker using the power switch. Wait a few seconds and turn it back on. Restart the app.
|
· The action button is the button on the top of the figure’s base that you can press down in order to advance dialogue, use your character’s special ability in the game, and interact with your environment.
|
You can, but you will only be able to play the initial portion of each character’s game unless you have Apptivity toy for that character.
To play without the toy, use two fingers to move around the screen, and a third finger to press the action button.
|
When playing the game, lift your figure or fingers off the screen for at least 4 seconds, and the pause menu will appear.
The checklist icon is the green notepaper at the left side of the screen. Tap it to access the checklist.
The checklist will indicate your next task or assignment within the game.
|
Check the bottom of the base for debris, and wipe it with a clean, dry cloth.
Wipe your screen with a soft, dry cloth to ensure the best conductivity with the figure.
Make sure you are holding the figure in the right location in order for it to be recognized. Hold it on the sides of the base where the black indented finger grips are. Do not wear gloves or mittens since the base needs to come in contact with your fingertips.
Make sure that you are not placing the figure on the black or white frame around the iPad screen. You must keep the figure only within the screen area.
|
Items that can be collected or interacted with have a glow around them. To collect an object, move the figure near the object or over it.
|
Once you complete the game for one character, you can access the mini-games within that game again through the main menu.
|
