How-To Print from iPad

How-To Print from Tablet

How-To Print from Web

Your photos are saved automatically to the Photo app on your device.

For best results, make sure doll parts are clean and dry before installing in Monster Maker.  If your design did not print completely, erase ink using the provided sponge.  Add water and a little dish soap (not included) and rub with the sponge until the ink is removed.  Dry the doll part thoroughly before putting it back in the Monster Maker.

Watch this video on how to assemble and use your BARBIE™ A Fashion Fairytale Glitterizer™ Playset.

Use your Email app to create a message, then browse your Photo app to find the photo and attach it to the email.

Touch the item you want to swap, then drag your finger left or right to cycle through the options.

• If you hear “Error,” ask an adult to unplug Car Maker from the wall, wait ten seconds and then plug it back in to reset. Car Maker may automatically go into the cooling cycle. Do not unplug during this time. If you continue to hear “Error” after multiple resets, this may be an indication of a mechanical problem with the door switch; please contact Consumer Services via service.mattel.com for assistance.

• Yes, for best results, allow the wax to cool for a few minutes before opening the mold. Twist the mold slightly (as you would an ice cube tray) to break the wax free. You can also run the mold under cold water, which will help speed up the cooling process. If the car body is wet, be sure to dry it completely before applying labels. Remove car body from the mold within 10 minutes. If the body is left in the mold for any longer, the wax may begin to crack.

The joystick directions match the direction that Barbie is facing, rather than the direction that the operator is facing. If Barbie is facing away from you and you move the joystick forward, Barbie will fly away from you. If she is facing towards you and you move the joystick forward, she will move towards you.

• Excess wax on the car body can be easily trimmed by hand or with the supplied design tool.

You will need a powered USB port from a computer, laptop or USB charger.

Fully charged, the Barbie™ Star Light Adventure RC Hoverboard will fly for about 7 minutes.

• If you cannot insert or remove the mold, locate the tabs on both sides of Car Maker (underneath handle), push them up and try again.

2.4 GHz.

Additional red, purple, and black markers are available in the Monster Maker Primary Extension Pack, sold separately.

• DO NOT start injecting wax until Car Maker prompts you to “Please pull down handle.” If you start the injection before this, it can cause blockage in the mold. Blockage can be cleared using the included tool (see CLEANING section in the instruction sheet).

The Hot Wheels Car Maker Troubleshooting Guide will help with any questions that arise during the car making process.